How To Get Ready For National Pool Opening Day

 In Above Ground Pools, In-Ground Pools, Opening and closing tips

National Pool Opening Day

There is a national holiday for each date on the calendar and also for every subject under the sun, but National Pool Opening Day is a holiday we can all rally round.

Schedule Your Pool Opening Today

As a pool owner, you understand there’s a lot of things that go into opening your pool, and National Pool Opening Day is an amazing reminder to check and maintain the many moving parts of your pool, to prepare for a happy, secure season of swimming pool.

Test the Water First

Once you peel the winter cap and realize the challenge before you, begin by assessing your pool chemical levels. A good water test kit is important for testing your pool’s chemical balance.

When stocking up for summertime on pool shock and pills, don’t forget to purchase water balance chemicals for pH, alk, and calcium. You might also need an algaecide and water clarifier to control algae and assist your filter removes finer particles out of the water.

Pool equipment

Examine the pool gear, mainly the filter and pump, but also other pool equipment like pool valves, chlorinators, heaters, cleaners, skimmers, ladders, slides and diving boards.

Start looking for any soil, mulch, trees or nearby plants that may get in the way of your equipment. Pool equipment does better in a sunny, dry location and not buried in bushes.

Pool cleaners have wearable components, and generally, require more frequent repairs than other pool equipment. Inspect closely for the cleaner parts that contact the surface, or debris totes or hose components that are worn.

Pool filters, either sand, DE or cartridge will need the filter press replaced at a single point. Sand lasts about 5 decades, DE grids for ten decades, and filter capsules 2-3 years for a good sized filter. You can prolong the life and improve filtration by using a Pool Filter Cleaner before and after opening your pool.

Pool pumps have electric motors that will fail at some point in time, usually at spring startup, or at the hottest aspect of the summer. When your motor will not turn or trips the breaker, it might be a loose cable, triggered GFCI or it might be an engine that is fried. Pumping problems may be air leaking to the pump, or a clogged impeller, or the water level.

Pool Accessories

Pool Ladders, Slides & Diving Boards possess a lot of bolts that need to be checked for tightness. Notably the step treads, which can loosen over time.

Chlorinators are normally easy to care for, but the chlorinator lid o-ring needs to be lubed often to protect the o-ring from the chlorine.

Pool Heaters

If you have a pool heater, the best spring maintenance you can do is clean out the base of the device to remove any leaves, cobwebs, and ant hills. Make sure the air vents and drain holes aren’t blocked in the cabinet. If leaves have collected inside a heat pump, or in addition to a gasoline heater exchanger, remove the heater top to wash out them.

 

 

Above-Ground Pools

Above ground, pools will join the hoses or pipes from the wall skimmer to the pool filter and then to the pool pump, and back to the pool return. Open the filter air bleeder, open the lines to be flooded by the valves and fill the pump with water. After being sure that the return and suction valves are available plugs the pump into a grounded electrical socket, and the pool skimmer and wall return aren’t plugged.

Inground Pools

Inground pools equipment reassembly is a bit more complicated, but it begins the exact same way, by screwing the drain wires back to the pump, heater, filter. Together with the water level up, pool plugs can be pulled out of the skimmer and wall contributes to flooding the lines. Contrary to Above ground pools, inground pumps sit above the water level. Fill the pump with water from a hose or hose, and seal. Open the filter air bleeder, open the return and suction valves, and then turn on the pump. Start-Up with a multiport valve on the ‘Waste’ place is a fantastic way to flush out the skimmer and drain, and it has much less resistance too, great for pumps that have difficulty ‘grabbing prime’.

 

National Pool Opening Day is the last Saturday in April. Make it your annual tradition to join us in welcoming spring by opening your pool! In case the final Saturday is too soon to start your pool, then join in by cleaning off your pool cover and prepping it to open when it’s warm enough. If you open the pool in May, it is the ideal time to pull the cover, examine the water, and then add another quart of algaecide or shock the pool.

If you need help opening your pool, contact us today!

Recent Posts

Leave a Comment

chemicalsretaining walls